The Fluke 726 Process Calibrator features two separate channels which allows it to measure, source and view process signals simultaneously. It is able to measure volts, mA, RTDs, thermocouples, frequency, and resistance for the testing of sensors and transmitters as well as sourcing/simulating volts, mA, thermocouples, RTDs, frequency, and pressure to calibrate transmitters. The Fluke 726 is able to achieve precise measurement and calibration source performance to accuracies of 0.01%, perform transmitter error percentage calculation and enable the user to interpret calibration results without the use of a calculator. Up to 8 calibration results can be stored in the on-board memory allowing field calibration data to be analysed at a later time.

• Frequency totalizer and frequency pulse train source mode for enhanced flowmeter testing
• HART mode inserts 250 ohm resistor in mA measure and source for compatibility with HART instrumentation
• Integrated pressure switch test allows you to capture the set, reset and deadband of a switch
• Custom RTD curves, add calibration constants for certified RTD probes for enhanced temperature measurement
• New voltage input protection design for improved reliability
• Measure or source pressure when combined with a pressure pump
• Perform fast linearity tests with auto step and auto ramp features
• Power transmitters during test using 24 V loop supply and simultaneous mA measurement
• Store frequently-used test setups for later use